Achtung! Bitte verwenden Sie die Firmware-Datei nur in Verbindung mit der CCU2 ab Version 2.25.14. Nach dem erfolgreichen Übertragen des Updates ist es erforderlich den HmIP-WTH einmal von der CCU2 ab- und wieder anzulernen, damit alle neuen Kanäle in der CCU2 angezeigt werden. Please note: Only use the firmware file in connection with the CCU2 from version 2.25.14. After the update has been successfully transferred, it is necessary to disconnect the HmIP-WTH from the CCU2 and teach-in the device again. So that all new channels are displayed in the CCU2. Changelog: Version 1.2.002 - 20160707 -------------------------------------------------------------- Version: Application: 1.2.002 Bootloader: 1.8.000 Library: 1.16.000 ** Related Hardware * 1624300D ** Bugfix * If a Firmware image is stored in the eeprom, the SMI signals an error on start up. ** Modification Version 1.2.001 - 20160422 -------------------------------------------------------------- Version: Application: 1.2.001 Bootloader: 1.8.000 Library: 1.16.000 ** Related Hardware * 1624300D ** Bugfix * Within the answer to "request status info" the currend brightness value instade the filtered value is send ** Modification Version 1.2.000 - 20160411 -------------------------------------------------------------- Version: Application: 1.2.000 Bootloader: 1.8.000 Library: 1.16.000 ** Related Hardware * 1624300D ** Bugfix ** Modification * Add dirict execution stop command to cancel motion activ timer. Version 1.0.004 - 20160310 -------------------------------------------------------------- Version: Application: 1.0.004 Bootloader: 1.8.000 Library: 1.14.001 ** Related Hardware * 1624300D ** Bugfix * the device was unable to handle the same IP address as Access Point and linkpartner ** Modification Version 1.0.3 - 20160120 -------------------------------------------------------------- Version: Application: 1.0.003 Bootloader: 1.8.000 Library: 1.14.000 ** Related Hardware * 1624300D ** Bugfix ** Modification